Commissioning of Atmos Boiler – Professional Start and Adjustment
Scope of Services
Our commissioning service includes fine adjustment of the boiler, flue gas measurement with draft pressure, and completion of the warranty protocol. The service includes travel to and from the site as well as on-site working time (see duration details for single and double systems).
Duration and Travel
On-site duration is approximately 4 hours for single systems and approximately 6 hours for double systems or combination boilers. Travel to and from the site is included in the scope of services.
Requirements for Commissioning
Upon arrival of our customer service technician, the following conditions must be met: The system is ready for operation, the boiler is switched off and cleaned, the system is filled with water and fully wired electrically, and all safety valves are connected.
If any of these requirements are not met, measurement and fine adjustment cannot be performed. If additional work becomes necessary, it will be billed separately based on measurement and working time (see section on additional costs).
Fuel Requirements
Sufficient suitable fuel is required for performing the flue gas measurement and fine adjustment. For HVG, use untreated log wood (cross-section approx. 12–15 cm, length 300 mm or 500 mm depending on boiler size, residual moisture 12–15%). For pellet boilers, pellets according to DIN Plus standard apply.
Measurement, Warranty, and Documentation
The flue gas measurement is documented with a printout and fine-tuned during the appointment. In addition, we fill out the warranty protocol so that all relevant measured values and settings are recorded in a traceable manner.
Payment and Invoice Information
CLIENT = INVOICE RECIPIENT - later changes to the invoice recipient cannot be considered! Payment is made in advance; the invoice is issued to the specified client/invoice recipient.
Additional Material and Labor Costs
If additional work is necessary because the above-mentioned requirements are not met or additional material is required, material costs will be calculated based on measurement and labor performed. Working hours are billed at €65.00/hour net.
Notes on Scheduling the Appointment
Please ensure that the system is fully prepared when our technician arrives and that the required fuel is available. Only then can the appointment be carried out efficiently and full performance be delivered.